cross arm
英 [krɒs ɑːm]
美 [krɔːs ɑːrm]
（电线杆）横担木；横臂
双语例句
- The application of electric conducting cross arm on ferroalloy refining furnace
导电横臂在铁合金精炼电炉上的应用 - The tower of the extra high voltage ( EHV) transmission line is heavy, tall, and it has longer cross arm and complex structure.
特高压线路的铁塔重量大、铁塔高、横担长、结构复杂。 - In Germany, it is impolite to cross your arm over people who are shaking hands, as well as chew gum in public.
在德国，用手搂抱正在握手的人是不礼貌的，当众嚼口香糖也一样。 - Where there is reed, there is water. a cross with the lowest arm being longer than the others.
水边长芦苇，有苇必有水。最低的边比其它边长的十字架。 - ( of a heraldic cross) having a cluster of three buttons or knobs at the end of each arm.
（指纹章学的十字交叉装饰）在每个纹章的末端都有一串的三个钮扣或者三个球形突出物。 - The insulator and the cross arm are both not electrified, and thus the utility model can be conveniently operated under the state of electrification.
由于绝缘子与横担均不带电，因此能够在带电的状态下操作，操作方便。 - The structure formation of towers is very novel, and the cross arm is rather long.
铁塔结构形式新颖，杆塔导线横担悬臂较长。 - Fig.1-98 Cross sections of various levels in arm ( Fig.1-97) to show approach through deep structures and relation to radial nerve.
图1-98上臂不同水平的横断面（图1-97），以显露入路经过的深部结构及桡神经的关系。 - Then make double cross arm active suspension model. After validating the accuracy specification of the suspension model, we simulate the model and analyze the dynamics of the model.
然后建立双横臂式前独立悬架，验证模型成功后，进行动力学分析。 - Experimental study has been carried out on the prestressed Steel Fiber Reinforced Concrete ( SFRC) pole fabricated by centrifugal shaping method with cross arm 27m above ground.
对研制的呼称高27m离心成型预应力钢纤维混凝土电杆进行了受力性能试验研究。 - A computer-integrated electro-proportional control system is adopted on the crane as well as fully automatic rapid telescopic system of single cylinder latch type and oval cross section lifting arm.
在起重机上采用计算机集成控制的电比例操作系统、单缸插销式全自动快速伸缩系统、完全椭圆形起重臂。 - The structure of steering rocking arm mechanism for new type cross country truck is described. Mathematical model of optimum design for steering rocking arm mechanism is built by space geometry method, and the parameters of steering rocking arm mechanism is optimized by composite method.
介绍了新型越野车转向摇臂机构的结构组成，用空间几何方法建立了转向摇臂机构优化设计的数学模型，并用复合形法对摇臂机构的参数进行了优化。 - Repairing the finger defects of larger area with subdermal vascular network flaps of cross-arm
交臂真皮下血管网皮瓣修复较大面积指皮肤缺损